Preparation of Tungsten Carbide-Based Solid Alloy Samples for Microstructural Analysis and Prospects of Analysis of Analysis Results

Authors

  • Parmonov S. T. Tashkent State Technical University Almalyk branch
  • Mirkhamitova D. Kh. Tashkent State Technical University Almalyk branch
  • Jadilova D. A. Tashkent State Technical University Almalyk branch

DOI:

https://doi.org/10.51699/ajsld.v2i10.2670

Keywords:

microstructural analysis, grinding, chemical-mechanical polishing, wax, rosin, copper cup

Abstract

In the article, the preparation of VK-6 brand tungsten carbide-based material samples produced by the Kirovgrad Hard Alloy Plant of Russia (Kirovgradskiy Zavod Tverdyx Splavov) and Uzbekistan's Almalik Mining Metallurgical Combine for microstructural analysis, stages of preparation for analysis, analysis of the obtained analysis results, and technological processes of pressing through the analysis results information on drawing conclusions about achievements and shortcomings is presented.

Downloads

Published

2023-10-14

How to Cite

S. T., P. ., D. Kh., M. ., & D. A., J. . (2023). Preparation of Tungsten Carbide-Based Solid Alloy Samples for Microstructural Analysis and Prospects of Analysis of Analysis Results. American Journal of Science and Learning for Development, 2(10), 11–15. https://doi.org/10.51699/ajsld.v2i10.2670

Issue

Vol. 2 No. 10 (2023): AMERICAN JOURNAL OF SCIENCE AND LEARNING FOR DEVELOPMENT (AJSLD)

Section

Articles